PS wall panels are prized for being lightweight, easy to cut, and simple to install compared to traditional materials like stone or tile. Whether you're a DIY homeowner tackling an accent wall or a contractor working on a commercial fit-out, this guide walks through the full installation process from start to finish.
Tools and Materials You'll Need
-
PS wall panels (measured for your wall area, plus 10% extra for cuts and waste)
-
Panel adhesive or construction adhesive suitable for polystyrene
-
Utility knife or fine-tooth saw for cutting
-
Measuring tape and pencil
-
Spirit level
-
Caulking gun (if using tube adhesive)
-
Clean cloth for wiping excess adhesive
Step 1: Prepare the Wall Surface
Start with a clean, dry, and flat wall surface. Remove any wallpaper, flaking paint, or debris, and fill any major holes or cracks. A smooth surface ensures the panels sit flush and the adhesive bonds properly.
Step 2: Measure and Plan Your Layout
Measure the height and width of your wall, then plan how the panels will align - especially around outlets, corners, and windows. Dry-fit the panels on the floor first if possible to visualize the pattern and minimize awkward cuts at the edges.
Step 3: Cut the Panels to Size
PS wall panels can be cut with a standard utility knife or a fine-tooth saw for thicker cuts. Measure twice before cutting, and use a straight edge to guide your blade for clean, precise lines - especially for panels that need to fit around fixtures.
Step 4: Apply Adhesive
Apply panel adhesive evenly across the back of each panel, following the manufacturer's recommended pattern (often a zigzag or dot pattern for even coverage). Avoid over-applying, as excess adhesive can seep out around the edges.
Step 5: Position and Press the Panel
Starting from a corner or the most visible section of the wall, press the panel firmly into place. Use a level to confirm it's straight before the adhesive sets. Hold or brace the panel for the time specified by your adhesive's instructions.
Step 6: Continue Panel by Panel
Work outward from your starting point, aligning each subsequent panel against the previous one. Check alignment with a level every few panels to prevent drift across the wall.
Step 7: Finish the Edges
Once all panels are installed, wipe away any excess adhesive with a clean cloth before it cures. Trim or caulk any small gaps at the edges or corners for a seamless, finished look.
Step 8: Let It Cure
Allow the adhesive to fully cure according to the manufacturer's guidelines before touching or cleaning the wall. This ensures a strong, lasting bond.
Maintenance After Installation
Once installed, PS wall panels require minimal upkeep. Clean with a soft cloth and mild soap as needed, and avoid harsh chemicals or abrasive tools that could damage the decorative surface.
Ready to start your project? Browse our full range of finishes in the PS Wall Panel Collection.
Frequently Asked Questions
Can PS wall panels be installed over existing tile?
In most cases, panels should be installed on a flat, clean surface. Existing tile with significant grout lines may need to be leveled or covered with backer board first for the best results.
Do I need special tools to cut PS wall panels?
No. A standard utility knife or fine-tooth saw is typically sufficient, making the material accessible for DIY installation.
How long does it take to install a full wall of PS panels?
Most standard accent walls can be completed in a single day, depending on wall size and the complexity of cuts needed around fixtures or corners.
What adhesive works best for PS wall panels?
A construction-grade adhesive designed for polystyrene or general interior paneling works best. Always check the panel manufacturer's recommendation before purchasing.
